Jiangsu Junjun resolves when using the smart shaker
Precautions when using the smart shaker:
1. Before using this product, please be sure to read the instruction manual carefully;
2. Please read the safety instructions and precautions in the manual carefully;
3, before starting the machine, please be sure to install the four corners of the machine according to the instructions in the manual;
4, in order to protect the normal operation of the compressor, please observe the following operations:
1) When the machine needs to be moved, the inclination angle should be less than 45 °
2) When moving the machine, make sure to use it after 24 hours
3) When the device temperature °C (room temperature +10 °C) and turn off and then turn on, make sure to believe that the interval between setting the temperature twice and turning it on again is greater than 10 minutes.
5, the equipment must be reliably grounded!
6. Please confirm the local power supply voltage before use;
7. One of the following situations must be unplugged and equipped with a power plug:
1) When opening the power box door and ventilation adjustment door of this equipment
2) When replacing the fuse
3) When the device fails and cannot be used normally
4) When the device is stopped for a long time
5) When moving equipment
8. The equipment should be placed on a firm and stable surface, and keep it horizontal.
9. There must be about 10cm clearance around the equipment;
10. If the equipment has cooling function and needs continuous cooling, it must be heated and treated in 10 days;
11. If the equipment has cooling function, the dust on the condenser next to the compressor must be cleaned every six months to ensure the cooling effect;
12. In the event that the experimental vessel breaks, remove the rocker immediately to remove the liquid and residual glass;
13. Experimental sample flow into the control panel may cause abnormal circuit control;
14, should always check the flask clip fixing screws to prevent the clamp off;
15, equipment should not be opened at will, otherwise it will affect the thermostat effect;
16. The outer coating of equipment shall not be in contact with volatile chemicals such as gasoline and banana water;
17. If the power cord is damaged, use the company's special accessories;
18, keep the inside and outside of the box clean, often clearing debris, stains;
19. Gravity opens and closes the equipment door, which can easily lead to equipment damage.
20, before opening the equipment box door should confirm that the rocker is at rest;
21. Never pull the power cord directly when dialing the equipment power plug.
Dongxing Aluminum Co., Ltd. , http://www.hljaluminumfoil.com