How do mahogany furniture go through autumn and winter?

How to maintain mahogany furniture in winter? Relevant people believe that as long as you pay attention to the following points, you can basically avoid the worries and let the furniture have a comfortable winter.

First, pay attention to stay away from heat sources when placing furniture, at least about 1 meter. If the furniture is too close to the heat source, it will quickly cause the moisture in the furniture wood to evaporate too much, causing the seams and shackles of the furniture to shrink, which will cause the smashing deformation panel to crack. It is best to wipe the beeswax on the back and inside of the furniture.

Second, the indoors increase the humidity as much as possible. If you often wipe the floor with a damp cloth or use a humidifier or fish, it is good for both people and furniture.

Third, the furniture should be placed flat and flat, not the four legs are not on a flat surface. The whole furniture should be perpendicular to the ground, otherwise it will easily cause deformation of the whole furniture and the door and other parts, which will eventually cause the seam to be slit and damage the life of the furniture.

4. Do not use a damp cloth to wipe the furniture dust. The furniture surface dust should be gently removed first, and then wiped with a cotton dry cloth to prevent the particles from damaging the surface of the furniture.

5. When the furniture moves, it is best to move it up, do not pull hard and lick, and easily cause the lower end of the leg and foot to split;

Sixth, furniture with drawers, it is recommended to drop a few drops of wax on the bottom of the drawer or on the drawer (frame) (the raft of the drawer), which will reduce friction and extend the service life.

Seven, mahogany furniture is best not to be placed directly next to high humidity objects.

New furniture sometimes has a sudden squeaking sound. As long as it is done according to the above requirements, there will be no problem. The sound is caused by the normal phenomenon caused by the shrinkage of the furniture panel. After the furniture has been passed for one winter, the factory can be repaired and restored to restore its new look.

Pet Black Film 

We have been in plastic film for more than 12 years ,our PET Black Film can be customized according

to clients requirement  such as light transmission.

Specification: 30mic-200mic other spec can be customized.

Use:Applicable to electronic products,instruments,electro-acoustic

Appearance: Black opaque with high surface brightness PET film

Item

Unit

Index

Test condition

Thickness tolerance

%

≤3

GB/T6682-2001

Transmittance

%

≤2

GB/T 2410-2008

Tensile strength

 

MD

Mpa

≥170

GB/T 1040.3

TD

Mpa

≥170

Elongation at

Break

MD

%

≥90

GB/T 1040.3

TD

≥90

Heat shrinkage (150℃30min)

MD

%

≤1.4

GB/T 16958-2008

TD

≤0.2

Haze

 

%

≥98

GB/T 2410-2008

Gloss

%

≥100

GB/T 2410-2008

Surface tension

Dyn/cm

≥52

GB/T 14216-2008


PET black film application

PET Black Film

Mylar Pet Film,Black Film Insulation Film,Black Polyester Film,Pet Black Film

Shijiazhuang dadao Packaging materials Co , https://www.ddplasticfilm.com