Analyze every packing action of automatic baler

1. The packing object is basically in the middle of the baler. First, the right top body rises and the front end of the belt is pressed. The belt is tightened on the object.

2, then the left acrosomatic body rises, compresses the appropriate position of the lower layer of the strap, the heating piece extends into the middle of the two bands, the middle knife rises, cuts the band,

3, Finally, the next strap is sent to the place to complete a work cycle.

Fully automatic baler action analysis:

The strap is delivered to the place → The strapping signal is received → The brake is released and the main motor starts

The first link: 1, the right top knife rises, withstands the right to take at the slide place 2, the “T” guide plate retreats 3, the proximity switch senses to withdraw the probe 4, the main motor stops, the brake pulls 5, the packing machine retreats With motor rotation, withdraw 0.35 seconds 6, the strap tightened on the object

The second link: 7, the main motor is started twice, the brake is engaged 8, the big swing rod is pulled twice, the belt 9 is tightened, the left acroupial body is raised, the lower belt 10 is pressed tightly, and the heating piece reaches into the middle of the two belts 11, The middle knife rises, cuts the tape 12, the middle knife drops 13, the middle knife rises again, the two tapes are firmly bonded 14, the middle knife descends, the left and right knifes simultaneously descend, the heater chip resets 16, and the skateboard retreats

The third link: 17, "T"-type guide reset 18, the proximity switch senses to send the probe 19, the belt motor starts, drives the belt to send 20, the big swing bar reset 21, the belt in place, with the head to the "T" type The proximity switch of the guide plate 22 senses the dual probe 23, the main motor stops, and the brake pulls in.