Maintenance of Kyushu Space Analytical Gas Detector

1.1 Notes

â—† The detector has undergone strict calibration before leaving the factory. Please do not replace any internal components after installation. If replacement is necessary, it is essential to recalibrate the device to ensure accurate readings.

â—† Under normal operating conditions, the sensor has a lifespan of two years. However, exposure to harsh environments or extreme conditions may shorten its service life. It is recommended to perform regular testing and maintenance at least once a year to ensure continued reliability.

â—† The detector's sensor is sensitive to high concentrations of gas. Exposure to such conditions may cause permanent damage to the sensor, leading to inaccurate readings or failure. Avoid exposing the device to gas levels beyond its specified range.

â—† Frequent power interruptions can affect the stability of the detection system. To prevent operational issues, try to maintain a consistent power supply. If power outages are unavoidable, make sure the device has sufficient time to stabilize before use.

â—† During operation, it is important to regularly check the functionality of the instrument. A minimum inspection interval of three months is recommended to ensure the detector is working properly and to identify any potential issues early on.

1.2 Analysis and Troubleshooting Common Faults

â—† After the alarm system is installed, you may experience an initial alarm or fault message during the first power-on and warm-up phase. This is normal. Try resetting the system and observe for a while. If the issue persists, further investigation may be needed.

â—† The power indicator is not lit.

Check if the power cable is correctly connected and confirm that the power supply is providing 24V. Reconnect and power on again to see if the indicator lights up. If everything seems in order but the issue remains, contact the manufacturer or return the unit for professional inspection and repair.

â—† The host does not display anything when powered on.

This could indicate a problem with the display unit or internal circuitry. First, verify the power connection and voltage as mentioned above. If the issue continues, it is advisable to send the device back to the factory for detailed diagnostics and possible repairs. Regular maintenance and proper handling will help extend the life of your gas detector and ensure safe and reliable performance over time.

Training Tables

Training table,High Quality Training table,Training table Details, CN

Queen Furniture Co., Ltd. , https://www.queenfurnitures.com